Magma ExpressBox 3T EB3T User Manual - page 29
Magma
ExpressBox 3T | Chapter 4 Technical Information
29
Chapter 4 Technical Information
Fan Speed and Noise Adjustment
For low power or self-cooled cards you can reduce the fan noise by moving the jumper found under the removable
cooling fan at the front of the chassis to the slowest speed setting. If the chassis gets hot during use, you should
increase the fan speed to provide more cooling.
You will need a pair of needle nose pliers or a similar tool used for grabbing small jumpers. Remove the fan cage at
the front of the chassis and you will see a small board as shown below.
The Factory Default is setting 2 (medium). The slowest speed is setting 4 and the fastest speed is setting F.
F = fastest 1 = fast 2 = medium (default)
3 = slow 4 = slowest
The factory "Default" setting is 2(medium).
The slowest speed setting is 4 and the fastest speed setting is F
Older EB3T unit – Fan Controller
Below are steps on how to access the Fan controller on older EB3T units (first generation EB3T model).