Magma ExpressBox 3T EB3T User Manual - page 48
Magma
ExpressBox 3T | Chapter 4 Technical Information
48
2.
Plug in Controller Card and secure it. Make sure the card is firmly seated into the PCIe slot.
How to Configure SAS / SATA Raid
IMPORTANT
This chapter describes how to configure the disk controller card. This software configuration is specific only
to vendor Areca. Different vendors (i.e. ATTO, Intel, LSI and etc.) of disk controller cards have their own
software utility for RAID configuration and management. If you are using a non-Areca card make sure to
check with the vendor or manufacturer of the card for further instructions.
Areca has its own Graphical User Interface for RAID configuration and management.
You need to install Archttp first, follow the
instructions below
1.
Go to
http://www.areca.com.tw
2.
Click Support & Downloads
3.
Go to Driver / Utility, select Windows
4.
Under "Windows-ArcHTTP" click, Version V2.3.4 to download
5.
Save File "winhttp_V2.3.4_130325.zip"
6.
Extract the File
7.
Click Install.exe to install Archttp
8.
After Installation, shutdown computer. Connect Thunderbolt cable to Magma EB3T and computer.
9.
Turn on the computer
NOTE: These steps are applicable to Windows 7, Windows 8 and Mac OSx. Use Firefox / Mozilla as your Browser to launch
the ARCHTTP.