Magma ExpressBox 3T EB3T User Manual - page 64
Magma
ExpressBox 3T | Chapter 6 Troubleshooting
64
1. If you are installing an X8 – Gen1 PCIE card: set SW1 to ON and SW2 to ON
2. If you are installing an x8 – Gen2 PCIE card: set SW1 to OFF and SW2 to ON
3. If you are installing an X4 – Gen1 PCIE card: set SW1 to ON and SW2 to OFF
4. If you are installing an x4 - Gen2 PCIE card: set SW1 to OFF and SW2 to OFF
NOTE: Default setting: 1= OFF; 2= OFF
Q: Can I daisy chain ExpressBox 3T with more ExpressBox 3T?
A: Yes, but realize that aggregate bandwidth is limited to 10Gbps through the Thunderbolt port and PCI address and IO space
can be limited so the type of cards installed in the chassis may limit the number that can be daisy chained successfully.
If a daisy chain device doesn’t work; check to see if a RED led (on the Magma Thunderbolt Card in the first slot of ExpressBox
3T) is on. If so, the daisy chained device is drawing too much power and the current limiting has kicked in and has turned off the
power to the downstream device.
Q: Will ExpressBox 3T show up in Apple System Profiler or Windows Device Manager without any PCIe cards installed?
Yes. In Apple System Profiler Thunderbolt Status: Connected ExpressBox 3T
In Windows Control Panel Device Manager View by connection
You should see these three PCI-to-PCI bridges. Right click on it and select “Properties”, select Hardware Ids from dropdown list,
you should see PCI\Ven_111D