Magna Carta FacilityPro POS 3000 Installation And User Manual - page 15
15 FacilityPro POS 3000 manual, version MAN9 PS3000 UKED 4512.doc
9)
service_timeout: default value 2000 (2 sec)
The maximum time (in ms) between signals sent from the cash register to the
terminal. If this time is exceeded, the terminal assumes there is no
communication with the cash register and displays an out or order message
(Figure 4-4). Value ‘0’ turns off this functionality.
10)
single_vend: default value 1
There can only be one transaction with an inserted card. In order to effect a
second payment with the same card, it must be taken out and re-inserted. If the
value is set to 0 the terminal can effect multiple transactions to the same card
without the card being taken out and re-inserted.
11)
stop_translog_full: value in standard configuration 0
value = 0: if the memory of the Magnabox for storing transaction data is full
(1000 transactions) the Magnabox will continue to work and new transactions
can be effected. Transaction data is then lost on a FIFO basis (First In First Out).
The counters in the Magnabox continue to store all relevant data so that no data
is lost at that level;
value = 1: as soon as the memory of the Magnabox for storing transaction data is
full (1000 transactions) the Magnabox will refuse to operate and no further
transactions can be effected until the Magnabox has been audited and the
transactions have been collected. The display of the Atlas will show
‘TRANSACTION FULL OUT OF ORDER’;
12)
user_confirmation: default value 1
value=1: payment will only be effectuated after confirmation from the
cardholder;
value=0: payment will be effectuated automatically as soon as the amount is
sent from the cash register to the payment terminal and a card is inserted,
unless the card is a Chipknip, in which case the customer is asked to confirm
before the amount is deducted from the card;
On the terminal data screen:
1)
Welcome text 1: standard value WELCOME
When the terminal is not active, two alternating screens will be shown on the
display of the terminal. This field contains the first line of text of the first
screen. If this field is not filled in the default value “WELCOME” will be used. The
second line will always be “YOUR CARD PLEASE”. The second screen will show the
date and the time.
2)
Welcome text 2: standard value empty
If this field is given a value, when the terminal is not active, three alternating
screens will be shown on the display of the terminal in stead of two (see above).
The third screen will show the text filled in in this field. To control the way lines
are shown (the position of lines) commands can be placed in the text. The
Magnabox will interpret these commands and implement them. The commands
for a line of text must be placed at the beginning of that line. The commands
are:
a)
‘\c’ center the text on the display
b)
‘\l’ left-align
the
text
c)
‘\r’ right-align the text
d)
‘\n’ new line
e)
‘\1’ this text must be on the 1st line
f)
‘\2’ this text must be on the 2nd line