Magnavox 50MF231D - 50" Digital Widescreen Plasma Tv User Manual - page 28
24
Camera, Camcorder, Game
&
Connect your camera, camcorder or game as shown.
é
Connect to
VIDEO
2 and
AUDIO L
3 for mono equipment. For
stereo equipment also connect
AUDIO R
3.
S-VHS quality with an S-VHS camcorder is obtained by connecting the
S-VHS cables with the
S-VIDEO
input 1 and
AUDIO
inputs 3.
Do not connect cable 1 and 2 at the same time. This may cause picture
distortion !
Headphone
&
Insert the plug into the headphone socket L as shown.
é
Press the
MUTE
button on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select Headphone volume to adjust the headphone
volume.
Side connections
Record with your recorder
Record a TV program
You can record a TV program using your recorders tuner without affecting your TV.
&
Select the channel number on your recorder.
é
Set your recorder to record.
See the handbook for your recorder.
Switching channel numbers on your TV does not disturb recording !
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio or television technician for
help.
Modifications -
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly approved by
Philips Consumer Electronics may void the user’s authority to operate the
equipment.
Cables -
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods to maintain compliance with FCC Rules
and Regulations.
Canadian notice -
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Avis Canadien -
Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
Regulatory Notices - Federal Communications Commission Notice
&
Press the
AV+
button repeatedly or select Source in the Settings menu
(see p. 13) to select
AV1
,
AV2
,
AV3
,
HDMI
, Side or TV, according to
where you connected your devices.
é
Press the cursor up/down.
“
Press
OK
.
To select connected devices
3
2
1
entry 2005 side+usb.eps
1
2
3
English
F
rançaise
Español
English_DFU_37132.indd 24
2006-07-12 9:46:05 AM