Magnum MFM-FS Product Instruction Manual - page 11
11
(5) Square Fold Adjustment
Turn the adjustment wheel to the right if the lower side of the
folded paper slants to the right. Turn the wheel to the left of the
lower side slants to the left.
* In other cases than single fold, place the folded paper with its
face down on Table 1 and make the adjustment.
(6) To Start Folding
Press the Start/Stop key. The system starts to fold the sheets continuously.
Press the Start/Stop again while the system is in operation, to stop.
* The counter continues to add up the number of sheets folded.
If the desired number of sheets only is to be fed, set that number by pressing 1000, 100, 10 keys.
Then the reduction mode lamp will be on.
Under the following conditions, the system will automatically stop feeding;
• When the start/stop key is pressed while there is no stock
• When the start/stop key is pressed while the paper feed lever is at the lower position.
• When the stock runs out
• When paper feed slip occurs
• When paper jam occurs at Table 1 and Table 2
• When paper stack table is full
• When a paper jam occurs at the paper ejecting unit
Press the clear/reset key to reset after the error is corrected.
(7) To Stop Paper Feed
Press the stop key to halt paper feed while the system is in operation.
(8) Correction of Paper Jam
Should paper jams occur, switch the power off immediately and remove the jammed sheets.
When the jammed paper is stuck around the folder roller or other parts, it can easily be removed by
detaching Table 1 and 2 from the unit. When the roller cover is opened, the system will stop the operation
in an instant.