Magnum MFM-FS Product Instruction Manual - page 13
13
4. Troubleshooting
Trouble
Possible Cause
Solution
The paper is not feeding correctly
Paper stuck just after its printed
Loosen the paper sufficiently or
feed the paper after its dry
Stains on the paper separator
Clean the paper feed separator
using the unit cleaner
Stains on the paper feed rubber
roller
Clean the paper chips or ink on
the paper feed roller with the unit
cleaner
The paper separator is worn out
Replace the paper separator with
a new one
The volume of paper loaded
on the paper feed table is not
enough
If the volume on the paper feed
table is not enough, it does not
feed since the paper detection
lever is installed. Load 20 sheets
or more.
The system does not operate even
after the start/stop key is pressed Paper jam inside the unit
Detach table 1 and 2 and remove
the paper in the unit
Paper creasing
Paper stuck just after its printed
Loosen the paper sufficiently or
feed the paper after it is dry
Stains on the paper separator
Clean the paper separator using
the unit cleaner
Stains on the paper feed roller
Clean the paper chips or ink on
the paper feed roller with the unit
cleaner
Stains on four paper fold rollers
Clean the stain on four fold rollers
using the unit cleaner
Table 1 and 2 are not properly set Reset properly
Paper jam in table 1 and 2
Detach table 1 and 2 and remove
the jammed paper
Improper fold position
The total length of the paper is
not standard size
Measure the total length of the
paper and adjust using the fine
adjustment knob
Drawing paper (125gsm
or lighter) cannot be folded
The surface of four fold rollers are
stained with paper chips or ink
(slippery situation)
Clean away the stain on four fold
rollers using the unit cleaner
Low room temperature
The paper gets stiff and hard to
fold at the low room temperature
in winter. Perform folding after
leaving the paper as it is for 3 to 4
hours at the temperature of 20-
25°C