Magnum MFM-FS Product Instruction Manual - page 9
9
Place the paper printed side down in case of fold-out.
Place the paper on the feed table so that it touches the paper guide and then tighten the paper guide
setscrews.
Lower the paper feed table lever and set the paper.
If the paper does not come in contact with the paper feed roller, it may be fed incorrectly. In such case,
the leading edge of the paper may touch the guide plate in the front and prevent the paper from being
fed. Reset it by pulling it backwards.
If the paper is curled or wrinkled it might cause the sheets to misfeed. Correct it before use.
In the case of printed paper, use it only after the ink is dry, otherwise the paper feed rubber roller, paper
separator, fold roller and other parts of the unit will be stained with ink and may get ink on subsequent
sheets.
Do not use ruled paper as the paper folding may deteriorate.
2. Operation Procedure
(1) Switch the power on.
Insert the plug into the power socket and switch the power on. Be sure to remove the power plug from
the socket after use.
(2) Setting Paper Fold Position
Pull the fold adjustment lever to move the stopper plate to the desired position on Table 1 and 2,
matching the stopper plate mark (?) with the position and leave the half-nut lever there. The stopper
plate automatically locks at the position where the half-nut lever remains.
* Incase of single fold only, all size paper should be set at the position of ‘All Sizes’ . Should wrinkles or
irregular folding occur in single fold, move the stopper plate until halting by the stopper adjustment
knob.
(3) Setting paper ejection roller
Set the paper ejection roller at the indication for the size of paper
stock used. If the roller is set at a wrong position, it may cause prob-
lems with stacking of folded sheets.
The paper folding length may be altered depending on the fold
type and paper curl may be caused by changes of temperature and
humidity. Therefore, whenever a paperjam occurs at the stage of
ejection, reset to adjust the paper eject roller to the best position.
(4) Setting paper stacking table
Pull out the paper stacking table and set it so that the ejected
sheets flows out smoothly.