Magnum MI-77100 Operating Manual - page 4
ASSEMBLY INSTRUCTIONS
For your convenience this mortiser is shipped from the factory partially assembled and requires
only minimal assembly and set up before being put into service.
ATTACH THE WORKPIECE STOP
The workpiece stop can be installed on the mortiser to suit
your needs or personal work preferences.
1. Thread the workpiece stop (A) into the threaded hole in
the fence.
2. Secure it on the fence.
INSTALL THE DOWN FEED HANDLE
The four holes in the down feed shaft allow you to
reposition the handle in the holes for better comfort
and convenience.
1. Loosen the lock knob (A).
2. Remove the handle (B) and reposition it as needed,
choosing the hole that provides the most comfortable
handle angle.
3. Re-tighten the lock knob(A) to secure the down feed
handle in position
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE
MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COMPLETED
THE ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE
POWER SOURCE UNTIL INSTRUCTED TO DO SO.
A
B
A