Magnum MI-77100 Operating Manual - page 8
ON/OFF POWER SWITCH
VERIFY ALL FOLLOWING CHECK POINTS BEFORE TURNING ON THE MORTISER.
FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURIES.
The mortiser is equipped with a ON/OFF dust-proof and lock
devise switch located on the left hand side of the mortiser head.
- To start the mortiser, unlock cover and press ON of the switch;
- To stop the mortiser, press OFF of the switch or press lock
cover.
SETTING THE DEPTH STOP
1.Transfer a reference line showing the desired depth of cut
onto the front face of the workpiece and then set the depth
stop (A):
2. Lower the chisel to the bottom of your depth reference line
then adjust the depth stop against the stop plate as shown(B)
to prevent the chisel from lowering any further.
NOTE: As a time saving convenience, the upper stop can be set to control the upward travel
of the head. This feature allows you to save time by raising the bit only enough to clear the
workpiece and allow you to reposition the workpiece without having to raise the head to its
maximum.
• MAKE SURE THE TWO SLIDE PLATES OF THE CHUCK COVER ARE CLOSED AND THEIR LOCK
KNOBS ARE TIGHTENED SECURELY.
• MAKE SURE THE CHISEL AND BIT ARE PROPERLY INSTALLED AND THAT THE BIT CHUCK
AND CHISEL LOCK LEVER ARE TIGHTENED SECURELY.
• WHEN THE MORTISER IS RUNNING CHECK TO SEE IF IT RUNS WITHOUT VIBRATION OR
SHAKING.
A
B