Reverse camera installation instructions issue: 1 - 01/03/2013 page 1 of 12 xuv500
Issue: 1 - 01/03/2013 page 2 of 12 xuv500 fitting time: 45 minutes parts supplied: reverse camera wiring harness tools and materials flat blade screw driver phillips head screw driver power drill cable ties xuv500 flashing tool.
Issue: 1 - 01/03/2013 page 3 of 12 xuv500 step 1: remove the following panels always refer to vehicle workshop manual when removing vehicle components left side kick trim: remove plastic nut at front, remove phillips head screw behind oval cover place. Remove front and rear scuff trims. Remove screw.
Issue: 1 - 01/03/2013 page 4 of 12 xuv500 step 2: remove the following panels always refer to vehicle workshop manual when removing vehicle components remove screws left side tail light assembly: pull back boot pinch mould, remove black cover above tail light and remove tail light. Pull out wiring r...
Issue: 1 - 01/03/2013 page 5 of 12 xuv500 step 3: remove the following panels tailgate trim cover: remove top and side panels by hand . Undo screws and remove pocket along bottom of main trim then remove tailgate trim, taking care to unplug interior light ..
Issue: 1 - 01/03/2013 page 6 of 12 xuv500 step 4: fitting overview looking at wiring kit, the short section with male/female plugs gets inserted behind tail light. The section with the cylindrical plug runs into the tailgate for the camera. The long section with single square plug runs into lhs kick...
Issue: 1 - 01/03/2013 page 7 of 12 xuv500 wiring the kit in from inside the car, pass the tailgate ‘t harness’ out behind the lhs tail light. Make a small cut in the wiring body grommet, then feed the cable through. Reseat the grommet correctly into the body. Then plug the harness in line with the e...
Issue: 1 - 01/03/2013 page 8 of 12 xuv500 camera mounting. Remove numberplate light housing, by undoing 2 x 10mm bolts from inside the tailgate, then unclipping the housing from outside the vehicle remove switch from light housing remove passenger side screw, then refit screw with camera attached to...
Issue: 1 - 01/03/2013 page 9 of 12 xuv500 wiring the camera run camera lead up towards the tailgate behind interior trims. Remove lhs wiring conduit, run cable through. Use lubricant to assist pulling through if needed reseat grommets for wiring conduit. Run camera lead to camera cable, securing wit...
Issue: 1 - 01/03/2013 page 10 of 12 xuv500 wiring to the front of vehicle run the remaining lead behind the lhs cargo bay trim, being sure to locate it low behind the trim to avoid fouling on mounting clips upon reassembly. Plug lead into video access plug in kick panel, tape connection and cable ti...
Issue: 1 - 01/03/2013 page 11 of 12 xuv500 step 5: reverse camera activation to activate the camera in the vehicle, enable the rvc in is (infotainment system) using xuv500 flashing tool as mentioned below: 1. Connect xuv500 flashing tool and select is (infotainment system) 2. Select “config” 3. In f...
Issue: 1 - 01/03/2013 page 12 of 12 xuv500 step 6: final test and image alignment with the engine running and the handbrake engaged, place the vehicle into reverse. The reverse image should look similar to the below image. Some slight adjustment to the camera may be necessary by loosening the camera...
