I n s t r u c t i o n m a n u a l warning: for your personal safety, read and understand before using. Save these instructions for future reference. English cutter model 4101rh 003504.
2 specifications • due to our continuing programme of research and development, the specifications herein are subject to change without notice. • note: specifications may differ from country to country. Symbols end104-2 the following show the symbols used for the tool. Be sure that you understand th...
3 general safety rules gea001-3 warning: read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (...
4 19. Store idle power tools out of the reach of chil- dren and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 20. Maintain power tools. Check for misalignment or binding of moving parts,...
5 functional description caution: • always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Portable residual current device connect the tool to a power supply and test the portable residual current device (prcd) before using the tool. Push the “...
6 loosen the wing bolt on the depth guide and move the base so that the end of the blade case is above the red line on the depth guide. Then tighten the wing bolt to secure the base. Note: • if the end of the blade case is under the red line on the depth guide, the outer flange may hit the workpiece...
7 installing or removing diamond wheel hold the outer flange with the wrench and loosen the hex socket head bolt clockwise with the hex wrench. Then remove the hex socket head bolt, outer flange and diamond wheel. Install the diamond wheel, outer flange and hex socket head bolt onto the spindle. Hol...
8 operation adjust the amount of water flow. Hold the tool firmly. Set the base plate on the workpiece to be cut without the wheel making any contact. Then turn the tool on and wait until the wheel attains full speed. Now simply move the tool for- ward over the workpiece surface, keeping it flat and...
9 when changing the wheel, clean the cover (b) at the same time. Loosen the screw securing the cover (b) and remove the cover (b). Wash off accumula- tion of dust inside the cover (b) and wipe it. Then attach the cover (b) to the tool by tightening the screw. Accumulation of dust inside the covers m...
Memo 10
Memo 11.
Makita corporation anjo, aichi, japan 884156b221.
