Makita 4101RH Instruction Manual - page 7
7
Installing or removing diamond wheel
Hold the outer flange with the wrench and loosen the hex socket head bolt
clockwise with the hex wrench. Then remove the hex socket head bolt, outer
flange and diamond wheel.
Install the diamond wheel, outer flange and hex socket head bolt onto the
spindle. Hold the outer flange with the wrench and tighten the hex socket head
bolt counterclockwise with the hex wrench. BE SURE TO TIGHTEN THE HEX
SOCKET HEAD BOLT SECURELY.
CAUTION:
•
Use only the Makita wrench to install or remove the wheel.
Installing water pipe
First, unplug the tool. Loosen the wing bolt on the depth guide and move the
base down. Install the water pipe on the blade case using the screw.
Attach the vinyl tube onto the water pipe and attach the adapter on the vinyl
tube to a faucet of water mains pressure. Adjust the amount of water flow by
simply adjusting the water cock.
Installing cover (A)
Install the cover (A) on the tool so that its side with “Upside
” mark faces
upward.
1. Wrench 22
2. Hex wrench
1
2
003528
1. Inner flange
2. Diamond wheel
3. Outer flange
4. Hex socket head bolt
2
3
4
1
003529
1. Wing bolt
2. Blade case
3. Water pipe
3
1
2
003536
1. Clamp
2. Cover (A)
2
1
003543