Makita BUB360 Instruction Manual - Assembly
5
the "HIGH/LOW" button again to restart.
When the tool does not work even after
pressing the "HIGH/LOW" button, the battery
power auto-stop is still at work. Charge the
battery cartridge before use.
•
When the remaining battery capacity becomes low:
Recharge the battery cartridge.
Switch action
1
2
011052
To start the tool, simply press the "HIGH/LOW" button. To
switch off, press the "OFF" button. To change the tool
speed, press the "HIGH/LOW" button. The first press on
this button is for high speed and the second press for low
speed and then each press on this button repeats the
high/low speed cycle alternatively.
Battery remaining capacity indicator (only for
models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light for
approx. three seconds.
Indicator lamps
Lighted
Off
Blinking
E
F
Remaining capacity
70% to 100%
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
011713
•
When only the lowermost indicator lamp (next to
the "E") blinks, or when none of the indicator lamps
light, the battery capacity has run out, so the tool
does not operate. In these cases, charge the
battery or replace the empty battery with a fully
charged one.
•
When two or more indicator lamps do not light even
after charging is complete, the battery has reached
the end of its service life.
•
When the upper two and lower two indicator lamps
light alternately, the battery may have
malfunctioned. Contact your local Makita
authorized service center.
NOTE:
•
The indicated capacity may be lower than the
actual level during use or immediately after using
the tool.
•
Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the long nozzle
1
2
3
011051
1. Hook
2. Button
3. Long nozzle
1. Indicator lamps
2. CHECK button
1. HIGH/LOW
button
2. OFF button