Makita BUB360 Instruction Manual - Operation
6
To install the long nozzle, push in onto the blower outlet
of the tool all the way.
1
1
011055
To remove the long nozzle, press its both buttons and
with the buttons being pressed pull it out.
Installing the shoulder strap
1
011057
Pull the hanger out of the tool.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy to
work with it.
OPERATION
Blowing
011054
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly
When blowing around a building, a big stone or a vehicle,
direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
Cleaning
011053
From time to time, wipe off the outside of the tool using a
cloth dampened in soapy water.
CAUTION:
•
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1
2
011056
1. Screwdriver
2. Brush holder cap
1. Limit mark
1. Hanger
1. Button