Mediterranean Tan MediterraneanTan Ultra Instruction Manual - page 10
10
6. Maintenance
1. Mediterranean Tan™ Ultra.
a. There is minimal maintenance to perform on the Mediterranean Tan™ Ultra. Make sure you keep the motor unit as
far away from your spraying area as possible.
b. Every night wipe over Mediterranean Tan™ Ultra with a damp cloth.
Please Note: Ensure no excess water is used as this will short circuit the unit.
Weekly Clean
c. Remove filter from unit (as seen in Figure 9) and wash under hot water. Once dry replace. It is a good idea to keep a
spare set of filters for your weekly change.
d.
Please see maintenance cleaning video at: http://www.mtwb.com.au/Main.asp?_=Videos
2. Air Hose.
a. Wipe the air hose daily with a damp cloth and store in a clean dry place.
3. Micro-intel Spray Gun - Daily Clean.
a. It is important to clean your Micro-intel Spray Gun daily.
b. At the end of the day or when the equipment will not be used any more, disconnect the Micro-intel Spray Gun from
the air hose.
c. Carefully unscrew the cup. If there is remaining solution pour the remaining solution into a proper storage container.
d. Rinse the cup under warm running water until clean.
e. Turn the gun upside down and allow warm running water to run into the plastic tube, pull back the trigger and allow
the water to flow out of the nozzle. Continue until clear.
f. Fill the cup about ¼ full with AIRBRUSH CLEANER. Reconnect the Micro-intel Spray Gun to Air Hose. Turn on the
Mediterranean Tan™ Ultra. Direct the Micro-intel Spray Gun to a safe area and spray the AIRBRUSH CLEANER
through the Micro-intel Spray Gun until the cup is empty and until the Spray becomes CLEAR.
Figure 9