Mediterranean Tan MediterraneanTan Ultra Instruction Manual - page 5
5
2. Set up and operate your Mediterranean Tan™ Ultra Tanning System
1. Plug the electrical lead to the Mediterranean Tan™ Ultra and plug the tanning system unit into a proper electrical outlet.
Make sure that the electric current you are connecting to is the same as your unit. (240v). DO NOT attempt to connect
the unit to the wrong electric current as this will not only damage your unit but also void your warranty.
2. Next, locate plastic hose end with the male end of the air hose and connect it to the female connector on the
Mediterranean Tan™ Ultra tanning system.
a. Align the two plastic nibs of the air hose with the corresponding grooves on the Mediterranean Tan™ Ultra
as seen in Figure 6.
Fig. 6
b. Once air hose is in position gently turn the hose anti-clockwise to lock it in place, as seen in Figure 7.
Fig. 7
c. To remove the air hose, gently turn hose clockwise to unlock and remove
If you have just finished spraying, the connector may be hot. Allow the Mediterranean Tan™ Ultra unit to cool
down for about 10 minutes before disconnecting the air hose from the Mediterranean Tan™ Ultra unit. Use Caution!
5
2
Set up and operate your PRINCESS
Tanning System:
1. Plug the PRINCESS
tanning system unit into a proper electrical outlet. Make sure that the electric current
you are connecting to is the same as your unit. (110v or 220v). DO NOT attempt to connect the unit to the wrong
electric current as this will not only damage your unit but also void your warranty.
2. Next, locate the male end of the air hose and connect it to the female quick connect on the PRINCESS
tanning system.
a. To insert the coupler pull back on the ring of the black coupler located on the PRINCESS
tanning
system and connect it to the male connector on the hose. Figure 6.
Fig. 6
b. Release the ring to allow the coupler to snap into place. The hose should now be connected to the
unit Figure 7.
Fig. 7
c. To remove the air hose, pull back on the ring of the black coupler and remove
If you have just finished spraying, the connector may be hot. Allow the PRINCESS unit to cool down
or about 10 minutes before disconnecting the air hose from the turbo unit. Use Caution!