Mediterranean Tan MediterraneanTan Ultra Instruction Manual - page 12
12
5. Troubleshooting
Q.
Mediterr
anean Tan™ Ultra turned ON. Air blows out of Micro-intel Spray Gun?
• This is correct. Air blows constantly when
Mediter
ranean Tan™ Ultra is ON.
Q.
Mediter
ranean Tan™ Ultra turned ON. Unit does not operate or blow air?
• Check that the unit is plugged in to proper electrical source. Be sure there is power at the electric source. If there is no
problem with electric supply, call for technical support.
Q.
Mediter
ranean Tan™ Ultra is turned ON the trigger is pulled back on Micro-intel Spray Gun but no solution comes out?
• Check that the cup is screwed firmly to Micro-intel Spray Gun.
• Check that there is no solution bubbling or leaking around the cup. See gun cleaning procedure on page 10.
• Try spraying again. If you still have a problem call for technical support.
Q. When
Mediter
ranean Tan™ Ultra is ON, Solution continues to spray from the Micro-intel Spray Gun without trigger being
pulled?
• Immediately turn
Mediter
ranean Tan™ Ultra OFF.
• Disconnect Micro-intel spray gun from air hose.
• Check Solution nozzle. Clean following the spray gun daily clean directions on page 10.
Q. Solution leaks around the top of the cup.
• Make sure the cup is screwed firmly to the body of the Micro-intel Spray Gun.
• Make sure the threads around the cup are clean and the threads inside the cup top assembly are clean.