MEGATRONIX VS 3525 Viking Installation Manual - page 16
APR/16/2002
Latched output / reset with ignition = The latched / reset with ignition output selection operates just like
the latched output but will reset or stop when the ignition is turned on.
ALARM FEATURE “
III
” PRORAMMING:
1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 6 times and hold it until three chirps with a long chirp is hearing then release the
valet switch. You are now in the Alarm feature ‘III’ programming mode.
3 Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Four Chirps /
One Chirp /
Two Chirps /
Three Chirps /
Press
LED four pulse
LED one pulse
LED two pulse
LED three pulse
T
ransmitte
r
Button
Factory Default
Setting
Exit the programming mode. (3 long chirp to confirm this exit.)
1
Exit the programming mode. (3 long chirp to confirm this exit.)
2
Wireless
door/window sensor
& PIR sensor
programming mode
Press & hold button
3 for 4 seconds to
delete the sensor
code
3
Override With
Password Pin Code
/
Override Without
Password Pin Code
/
4
Press & hold button
4 for 4 seconds to
delete the Password
pin code
Password pin code
programming
“TEST” Mode for
Zone 5 / Wireless
door/window sensor
& PIR sensor
“TEST” Mode for
Zone 4 / the Optional
Sensor connected to
4 pin plug.
“TEST” Mode for
Zone 2 / instant
trigger &
5
Zone 3 / Door trigger
6
Adjusting and Testing Zone 1 / Built-in Shock Sensor. Press
button will decrease
sensitivity by one.
7
Adjusting and Testing Zone 1 / Built-in Shock Sensor. Press
button will increase
sensitivity by one.
Exit
: Turn Ignition to 'ON' position / leave it for 15 seconds / press button
or
. A 3 long chirps & 3
parking light flashes to confirm exit 1-4
Program The Wireless PIR Sensor or Wireless Door/Window Sensor.
This system has a very unique interfacing with optional sensor, to extend more protection, such as PIR
(IR-70S) sensor or Door/Window sensor. (DS-70S)
For example, in your garage you can put a PIR for protection. (A device to detect person's movement in a
protected area.) If system armed, a person walk through the detect area, the siren inside the car will
alarming to raise the attention to the owner.
So the same thing applies in door/window sensor, (A device to detect door/window open.) you may put the
sensor to the garage door or window. If system armed, a person opens the door or window, the siren will
alarm.
Set the PIR and door/window sensor the same code if you use both of them.
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 6 times and hold it until three chirps with a long chirp is hearing then release the
valet switch. You are now in the Alarm feature ‘III’ programming mode.
Program:
1. Press and release the transmitter
button once, [2] LED flash, [2] siren/horn chirp to indicate your are
in features “Sensor Programming mode”.
2. Activate the sensor to let the system program it's code. [2] Chirps to confirm programmed. (Only one code
could be program)
16