MEGATRONIX VS 3525 Viking Installation Manual - page 19
APR/16/2002
H9/6 Brown/White
Wire = Factory
Security Rearm
Signal Output
H9/6 Brown/White
Wire = (-) 200ma
Horn Output
6
Temperature-Control
Starting
-
7 F (
-
20
C)
Temperature-Control
Starting
-
22 F (
-
30
C)
Temperature-Control
Starting OFF
Temperature-Control
Starting 5 F (
-
15 C)
7
Exit
: Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
START FEATURE “
II
” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 10 times and hold it until five chirps with a long chirp is hearing then release the
valet switch. You are now in the Start feature ‘II’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Four Chirps /
One Chirp /
Two Chirps /
Three Chirps /
Press
LED four pulse
LED one pulse
LED two pulse
LED three pulse
T
ransmitte
r
Button
Factory Default
Setting
Exit the programming mode. (3 long chirp to confirm this exit.)
1
Exit the programming mode. (3 long chirp to confirm this exit.)
2
Tachometer
checking type.
Voltage checking
type
Timer checking type
3
RPM learning
4
Start Timer:
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4 chirps),
1.4-second (5 chirps), 1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps), 4.0-second (10 chirps),
0.6-second
Start the system for TESTING & ADJUSTMENT
5
Hi check level
Low check level
6
Stop the remote start system for TESTING & ADJUSTMENT
7
Exit
: Press the
or
button on the transmitter. A 3 long chirps & 3 parking light flashes to confirm
exit.
TACHOMETER CHECKING TYPE
Enter Start Feature ‘II’ Programming Mode:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 10 times and hold it until five chirps with a long chirp is hearing then release the
valet switch. You are now in the Start feature ‘II’ programming mode.
Select “Checking Type”:
3. Press and release the transmitter
button once to set the “Tachometer Checking Type”. [1] LED flash,
[1] chirp to Confirm this setting.
4. Once you complete step 3, you can program “RPM Learning Mode” as below:
RPM Learning
While the system stay in Start Feature “II” programming mode,
1. Press and release the transmitter
button once, [1] chirp to indicate your are in features “RPM
Learning mode”.
2. Start the vehicle with the key. (While the engine is running, the parking & LED will flash, If don’t, please
check tachometer White/Red wire connection. (H6/8)
3. Press and hold the valet switch for 2 seconds until a long chirp and the LED light constant for two seconds.
The RPM signal is learned.
4. Once you complete step 3, turn off the ignition switch to stop the engine then you can adjust and test
“Check Level” as below:
19