Modern Fan Co aurora flush Installation Instructions Manual - page 4
Modern Fan / Period Arts Fan Controls
Our ceiling fans do not use conventional pull chains (with the exception of
the Industry model). When ordering your fan, you should have selected the
control that was most appropriate for your fan and electrical requirements.
Third party controls are generally compatible but must be FAN SPEED
CONTROLS with specific speed settings. Continuous, variable speed
controls or rheostats are not compatible with our fans, are likely to cause
motor noise and will void your ceiling fan warranty.
A basic fan control used to operate a fan only, providing four
speeds. Can be used in combination with a separate light
switch/dimmer in a double-gang wall box to control a fan with
light.
Control options are as follows:
Intended for operation of a fan with light. Requires
two circuits (three wires). #002 provides four speeds
and full range dimming; #002ND (for fluorescent
lights) provides three speeds and on/off switching of
light.
Designed for independent operation of a fan and light using
only one circuit (two wires). Provides three speeds and full
range dimming (for halogen or incandescent lamps) or “on/off”
switching (for fluorescent lamps) and wires into wall box.
Designed for independent operation of a fan and light using
only one circuit (two wires). Provides three speeds and full
range dimming (for halogen or incandescent lamps) or “on/off”
switching (for fluorescent lamps) and comes with a wall
hanging bracket.
A combination control package including our #004 Fan &
Light Control and our #003 Remote Control handset. Provides
three speeds and full range dimming (for halogen or
incandescent lamps) or “on/off” switching (for fluorescent
lamps) from wall control and compatible remote handset.
#001- Fan Speed Control
#002/002ND- Three Wire Fan Speed & Light Control
#003- Handheld Remote Control
#004- Two Wire Fan Speed & Light Control
#005- Two Wire Wall Control with Remote Handset
A three speed fan control designed to control two fans
(#009A) or three to five fans (#009B) on a single circuit.
Separate control/switching of lights must be planned for if this
control is to be used for fans with lights.
#009A/009B- Multi-Fan Speed Controls