Be sure to read this manual before using the product in order to ensure safe operation. Gec9 owner s manual 1.
Rear panel 2 1- overview lp1 lp2 lp3 lp4 lp5 lp6 1 2 3 4 5 top panel 6 11 12 16 17 18 19 7 9 8 10 10 15 14 13 (1) presets these switches instantly recall the settings stored in the corresponding preset 1-5 (2) mute/clean (3) bank up / down (4) loop1~6 program keys when pressed, press the active pres...
3 (7) buf in (buffered input) signal input via this jack is fed to a buffer circuit prior to being sent to the loops. (8) dc jack 5.5 x 2.1 mm type, use negative center dc 9v / 500ma power supply. (9) nbuf in (non buffered input) this jack bypasses the buffer circuit and directly sends singal to the...
Press preset switches to recall presettings, the corresponding led lights on when a preset is active. Press the active preset led will be turned off. Recall / bypass operation will not change the mute status. 3- recall presetting and bypass whole loop switch again will bypass the whole loop, the cor...
5 dimensions....................................16.9(l) x3.8(w)x1.22(h) inch weight...............................................................................1800g power supply...........................................Dc9v (negative center) current drain............................................
Configuration 2 - separate loops as footswitch buf out (a.O.) s1 r1 s2 r2 s3 r3 s4 r4 s5 r5 s6 r6 out7(n.O) r7 s7 (n.C) in7 out8(n.O) r8 s8 (n.C) in8 r9 s9 (n.C) in9 dc9v nbuf in lout1 loop2 loop3 loop4 loop5 loop6 tuner input ch1 send return loop1 = amp preamp clean ch2 amp head ch3 in this configu...
Configuration 3 - use multiple amplifiers in this configuration, the separate loop9 is used to choose signal path to different amps. Lout2 buf out (a.O.) s1 r1 s2 r2 s3 r3 s4 r4 s5 r5 s6 r6 out7(n.O) r7 s7 (n.C) in7 out8(n.O) r8 s8 (n.C) in8 out9(n.O) r9 s9 (n.C) in9 buf in dc9v nbuf in lout1 loop2 ...
Buf out (a.O.) s1 r1 s2 r2 s3 r3 s4 r4 s5 r5 s6 r6 out7(n.O) s7 (n.C) in7 out8(n.O) r8 s8 (n.C) in8 r9 s9 (n.C) in9 dc9v nbuf in lout1 fx2 fx1 fx3 fx5 tuner clean lout2 out9(n.O) buf in input return send s5 r5 fx4 amp ex loop pedals pedals in front of amp buf out (a.O.) s1 r1 s2 r2 s3 r3 s4 r4 s5 r5...
