Moen GEC9 Owner's Manual - 5- Mute / Clean
Press preset switches to recall presettings, the corresponding
LED lights on when a preset is active. Press the active preset
LED will be turned off.
Recall / bypass operation will not change the MUTE status.
3- Recall Presetting and Bypass whole loop
switch again will bypass the whole loop, the corresponding
5- Mute / CLEAN
Press MUTE /CLEAN switch to mute the LOUT and send input
jack signal to CLEAN jack, the MUTE status LED will turn on.
do not change MUTE status.
MUTE function works individually, recall / bypass opertations
To cancel MUTE function by pressing this switch again.
6- Bank UP/DOWN
GEC9 have 10 banks from A to J, each bank store 5 presets.
Press BANK UP or BANK DOWN switches to change the bank,
the numerical bank display blinks when the bank is about to be
4
7- Programming
Program keys are inactive when the pedal works in bypass mode.
(All presets LED are off), the keys will be active when a preset
is active, press the program keys to turn on/off corresponding
Loops, the loop status LED will be on/off accordingly. All loop
INPUT
2- Signal Path
Guitar signal feeds into GEC9 input (NBUF IN or BUF IN), enters series
LOOP1~LOOP6 when MUTE switch is off, then outputs from LOUT1 and LOUT2.
If MUTE is on, the signal outputs directly to CLEAN jack.
LOOP1
LOOP2
LOOP3
LOOP4
LOOP5
LOOP6
LOUT1
LOUT2
CLEAN
BUF OUT (A.O)
LOOP7
IN7
OUT7
LOOP8
IN8
OUT8
LOOP9
IN9
OUT9
The BUF OUT jack always outputs buffered input signal.
changed. Press any preset switch to recall new bank presets.
on/off status are automatically stored into non-volatile memory
which will be still available even the power supply is removed.