Moen GEC9 Owner's Manual - page 3
3
(7) BUF IN (Buffered Input)
Signal input via this jack is fed to a buffer circuit prior to being sent to the loops.
(8) DC Jack
5.5 x 2.1 mm type, use negative center DC 9V / 500mA power supply.
(9) NBUF IN (Non Buffered input)
This jack bypasses the buffer circuit and directly sends singal to the loops.
the BUF IN jack is automatically disconnected when a plug is inserted into it.
(10) LOUT1 and LOUT2
Output jacks for series loops (LOOP1 ~ 6), the input signal via buffered or non-bufferd
(11) S1
This is send jack of LOOP1, connects to input jack of guitar effect.
(12) R1
This is return jack of LOOP1, connects to output jack of guitar effect.
(13) EARTH TERMINAL
Connect the commander frame to earth through this terminal.
(14) BUF OUT (ALWAYS OUTPUT)
Singal from INPUT goes through a buffer circuit, one branch feeds to LOOP1 ~LOOP6,
The other branch feeds to BUF OUT(A.O) jack.
Input jacks reaches the two jacks via 6 series loops, LOUT 1 and LOUT2 jacks are
Internally connected in parallel.
(15) CLEAN
When LOUT is muted, the input signal via buffered or non-bufferd reaches this jack.
(16) IN7
(17) S7(N.C)
SEND jack of separate LOOP7, this jack should be connected to the input on effect
Input of separate LOOP7.
unit. When LOOP7 is on, signal from IN7 reaches SEND jack, enters external
effect then back to R7 (RETURN jack), finally reaches OUT7 jack. When LOOP7
is off, the signal from IN7 directly reaches OUT7.
This jack also functions as latching N.C (Normally Closed) switch which works
as footswitch to control amplifier channel. The jack is
“
closed
”
/
“
open
”
when LP7
is off/on.
(18) R7
RETURN jack of separate LOOP7.
(19) OUT7(N.O)
OUTPUT jack of the separate LOOP7, This jack also functions as latching N.O
(Normally Open) switch which works as footswitch to control amplifier channel.
The jack is
“
open
”
/
“
closed
”
when LP7 is off/on.(Note: Leave RETURN7 unplugged)