N-Com B901 User Instructions And Safety - page 21
EN
22
3.
In the case where one of the systems presses the “N” key or falls outside the connection
range, the group intercom is interrupted.
Smart Conference connection
Premere contemporaneamente i tasti “” e “”.
Activation is
confirmed by a beep in the helmet and by the voice message
“
Group Intercom”.
Smart Conference disconnection
Briefly press the “ON” key. Disconnection is confirmed by the
voice announcement “
Group Intercom ended.
N.B.: During a “Smart Conference” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
15. “UNIVERSAL INTERCOM” INTERCOM
The N-Com B901 system can be connected via Bluetooth to intercom systems of other brands or to
N-Com systems other than the “900” series, thanks to the UNIVERSAL INTERCOM function.
Important: N-Com systems other than the “900” series must be paired up to the N-Com B901 by
following the procedure “
Pairing up the Universal Intercom”.
Caution: Visit the www.n-com.it website for the list of compatible N-Com systems.
15.1.
Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to the other intercom (from now on referred to as Intercom B)
as if it was a mobile phone.
1.
Make sure the B901 is turned off;
2.
Put the system in the “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until the blue LED starts flashing;
3.
Press the pushbutton “” until you reach the option “
Universal intercom pair up” mode.
4.
Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual);
5.
After a few seconds, Intercom B will emit the “phone connection” confirmation beep;
N.B.: The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.
15.2.
Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B901 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 14).
Intercom B may receive a dialing one that must be answered with a phone reply command.
From intercom B
Press the “
Voice call / Dial last number called” command.
To disconnect the intercom, press “
Voice call / Dial last number called” once again.