NAD M15 HD Owner's Manual - page 41
CONDITION
POSSIBLE CAUSES
POSSIBLE SOLUTIONS
No sound from all channels.
• AC power unplugged.
• Check AC cable connection and outlet.
• Power not switched on.
• Outlet has no power.
No sound from some channels.
• Faulty/missing cables.
• Check cables.
• ’Speaker Configuration’ channel (s) set to
“OFF”.
• Check ‘Speaker Configuration’ menu.
• Power-amp connections faulty.
• Check power amplifier and cabling.
No sound from surround channels.
• No surround listening mode is engaged.
• Select appropriate listening mode.
• Surround-channels set to “OFF” on ‘Speaker
Configuration’ menu.
• Correct ‘Speaker Configuration’ or ‘Speaker
Levels’ settings.
• Surround-channels level set too low on
‘Speaker Levels’ menu.
No sound from Subwoofer.
• Subwoofer is off, not powered or improperly
connected.
• Power-up subwoofer, check Sub’s AC outlet
or check connections.
• Subwoofer set to “OFF” on ‘Speaker
Configuration’ menu.
• Correct ‘Speaker Configuration’ or ’Speaker
Levels’ settings.
• Sub level set too low on ‘Speaker Levels’
menu.
No sound from Center channel.
• Source is a 2/0 (etc.). Dolby Digital or DTS
recording without center channel.
• Play a known 5.1-channel recording or select
Dolby Pro Logic IIx Music mode.
• Center set to “OFF” on ‘Speaker Configuration’
menu.
• Correct ‘Speaker Configuration’ or ‘Speaker
Levels’ settings.
• Center level set too low on ‘Speaker Levels’
menu.
No Dolby Digital/DTS.
• Source’s digital output is not connected to a
M15 HD digital input.
• Check connections.
• Source component not configured for
multichannel digital output.
• Check source component setup.
M15 HD does not respond to HTRM remote.
• Batteries are flat or incorrectly inserted.
• Check batteries.
• IR transmitter window on remote or IR A/V
Receiver window on M15 HD is obstructed.
• Check IR windows and ensure clear line-of-sight
from remote to M15 HD.
• M15 HD front panel is in very bright sunlight
or ambient light.
• Reduce sunlight/room lighting.
M15 HD does not respond to front panel
commands or remote control.
• Microprocessor error.
• Power-down the M15 HD via the rear panel
Power switch and unplug it from the AC outlet.
• M15 HD may have over heated.
• Wait five minutes, re-connect and power up.
• 12V TRIGGER IN/OUT is set to AUTO position.
• Switch 12V TRIGGER IN/OUT to OFF position.
Factory defaults for 120V version only : Press simultaneously Source + Tone Defeat
Factory defaults for 230V version only : Press simultaneously Source + Tone Defeat
REFERENCE
TROUBLESHOOTING
41
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ