NAD T 747 Owner's Manual - page 31
FRONT PANEL DISPLAY SETUP
The Vacuum Fluorescent Display (VFD) and On-Screen Display (OSD) can be
shown in various ways by navigating through the parameters at the “Front
Panel Display Setup” menu. Use a combination of [ ] or [ENTER] and [
]
keys to step through the “Front Panel Display Setup” menu items.
DISPLAY
Select “On” to display all applicable data or characters at the VFD. Nothing
will be shown at VFD if “Temp” is selected. However at “Temp” setting,
whenever any of the front panel controls or their corresponding keys in the
remote control is activated, the appropriate VFD characters will be shown
temporarily and then fade away.
DIMMER
If it is desired to reduce the brightness of the VFD, set Dimmer to “Dim”.
Otherwise, select “Bright” to return to normal VFD brightness.
LINE 1, LINE 2
The VFD shows two main lines of data or characters. Line 2 is the line of
data or characters located at the lower bottom of the VFD while directly
above it is Line 1. For both lines, one can select which display could be
shown by choosing through the following
Main Source: Shows the active Source.
Volume: Current Volume level is shown.
Listening Mode: Selected Listening Mode is shown.
Audio Src Format: Shows the audio format detected at the active Source.
zone 2 Source: The assigned Source for the applicable Zone is shown.
Off: Select “Off” if it is desired not to show any data at the applicable Line.
TEMP LINE
Choose between Line 1 and Line 2 as the desired line where VFD will be
temporarily shown if “Temp” is selected at “Display” option as described
above.
NOTE
Theconfigurationssetforthat“FrontPanelDisplaySetup”arecarried
overwheneveritisenabledduringA/VPresetsetting.Referalsotothe
itemaboutA/VPRESETSundertheUSINGTHET747–SETUPMENU
segmentoftheOPERATIONsection.
VIDEO SETUP
This menu allows you to set the display resolution of the T 747 along with
the compatible video format setting and picture setup.
VIDEO FORMAT
There are 2 options under Video format – Resolution to Display and Video
Format.
Resolution to Display: The T 747 has the excellent ability to
upconvert standard definition video contents to high definition video
signal. Depending upon your TV/Monitor’s resolution capabilities, select
the applicable resolution settings - Auto, 480i/576i, 480p/576p, 1080i
and 1080p.When “Auto” is selected, the T 747 automatically selects the
highest resolution compatible with the connected TV/Monitor.
Note that if the display is connected to Composite or S-Video Monitor
OUT, the video output resolution must be set to 480i or 576i to view
content.
When you change the resolution setting, you will be prompted to Save
or Cancel the resolution change as per the message shown in OSD.
Press the [ ] to save the new resolution or [ ] to cancel the change
in resolution.
IMPORTANT NOTES
• Whenusingcomponentvideooutput,astandarddefinitionvideocan
beupscaledonlyupto1080i.
• Ifyouinadvertentlyselectedaresolutionsetting(like1080p)thatyour
TV/Monitordoesnotsupport,thevideodisplaywillgoblank.Torestore
videodisplay,press[ ]orturnOFF/ONtheT747.
OPERATION
USING THE T 747 – SETUP MENU
0
EN
G
LIS
H
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LIA
N
O
D
EU
TS
CH
N
ED
ER
LA
N
D
S
SV
EN
SK
A
РУ
СС
К
И
Й