NAD T785 Owner's Manual - page 13

ABOUT THE ON-SCREEN DISPLAY (OSD)

The T 785 receiver employs a simple, self-explanatory system of on-screen 

display “menus” that will appear on the connected video monitor/TV. These are 

required during the setup process (and are useful in day-to-day operation), so 

be sure to connect the monitor/TV before proceeding with setup.

DISPLAY THE OSD

Press either   or ENTER buttons of the HTRC 1 remote control or front panel 

to display the T 785’s Main Menu on your video monitor/TV. If the OSD does 

not appear, check your MONITOR OUT connections.

NAVIGATING THE OSD AND MAKING CHANGES

To navigate through the OSD menu options, please do the following using 

the HTRC 1 or corresponding front panel buttons: 

1  Press   to select a menu item. Use 

 keys or in some cases, ENTER, 

to move up or down the Menu selections. Repeatedly press   to 

advance or go further into sub-menus of a desired menu item.

2  Use 

 keys to set or change the parameter value (setting) of a menu 

item.

3  Press   to save the settings or changes done on the current menu or 

sub-menu. Pressing   will also return the user to the previous menu or 

exit from a particular menu.

MAIN MENU

The Main Menu contains the menu options for ‘Listening Mode’, ‘DSP 

Options’, ‘Tone Controls’, ‘Picture Controls’, ‘Zone Controls’ and access to 

‘Setup Menu.’

To navigate through these Main Menu options and their sub-menu 

selections, please refer to and follow the directions stated in the sections 

‘Display the OSD’ and ‘Navigating the OSD and Making Changes.’ 

NOTE

The individual configurations set forth at ‘Listening Mode’, ‘DSP Options’, 

‘Tone Controls’ and ‘Picture Controls’  are carried over whenever they are 

enabled during A/V Preset setting. Please see the section ‘AV Presets’ for 

reference.

LISTENING MODE

The T 785 offers distinct listening modes, tailored for different types of 

recording or program material. With a two-channel (Stereo) source, the 

following listening modes can be selected:

STEREO

All output is directed to the front left/right channels. Low frequencies are 

directed to the subwoofer if one is present in the Speaker settings. Select 

‘Stereo’ when you wish to listen to a stereo (or monaural) production, such 

as music CD or FM broadcast, without surround enhancement. Stereo 

recordings whether in PCM/digital or analog form and whether surround-

encoded or not encoded, are reproduced as recorded. Multi-channel digital 

recordings (Dolby Digital and DTS) are reproduced in “Stereo Downmix” 

mode via the front left/right channels only as Lt/Rt (left/right-total) signals.

DIRECT

The analog or digital sources are automatically played in their native 

formats. All the source’s audio channels are reproduced directly. This 

mode recreates the original sound most faithfully thereby producing 

outstandingly high quality audio.

PRO LOGIC

Two-channel recordings, whether stereo or surround-encoded, are 

reproduced with Dolby Pro Logic surround processing, yielding output to 

front left/right, center and discrete left/right surround channels (assuming 

these are present in the current ‘Speaker Configuration’). The surround 

channel is monophonic, but it is reproduced in both surround speakers.

OPERATION

USING THE T 785 – MAIN MENU

13

ENGLISH