NAD T785 Owner's Manual - page 48

OPERATION

USING THE HTRC 1 REMOTE CONTROL

BATTERY INSTALLATION

Press in and lift tab to remove battery cover out from recess

Place batteries into opening. Ensure the correct polarity is observed

Press battery cover into place until it ‘clicks’ closed

SLEEP MODE

The Sleep Mode timer will switch the T 785 to Standby mode automatically 

after a preset number of minutes. Pressing the HTRC 1’s SLEEP button once 

will display the setting of the sleep time increment.  Pressing the HTRC 1’s 

SLEEP button a second time within a 3-second period will change the 

sleep time increment in 15-minute intervals, after which time the T 785 will 

automatically switch into Standby mode.  

To adjust the sleep delay, press the HTRC 1’s SLEEP button twice; first 

to display the sleep time increment, and a second time to change the 

sleep time increment.  The sleep time increment and a “SLEEP” icon will 

continuously display on the T 785’s front panel Vacuum Fluorescent Display 

(VFD). Each consecutive press increases the sleep time in 15-minute 

increments from 15 to 90 minutes. To cancel the sleep mode, continue 

pressing the HTRC 1’s SLEEP button until “SLEEP OFF” displays on the VFD.  

Switching the T 785 to standby from either the HTRC 1’s OFF or the T 785’s 

STANDBY button will also cancel the sleep mode

USING THE ZR 4 REMOTE CONTROL

The ZR 4 remote control is a discrete compact remote for controlling the 

T 785 from various rooms other than the main room. The ZR 4 remote 

allows full separate control of the source selection irrespective to the main 

room. This means the zone input may be completely different, audio and 

video, from the main input and thus corresponding volume levels as well.

If one wishes to enjoy the same source, as the main room the ZR 4 remote 

has a [LOCAL] button to allow simultaneous listening, but with full separate 

volume levels.

To mute the Zone Volume level, press [MUTE] on the ZR 4. If the “Zone 

Controls” OSD menu is ON, the Zone “Volume” level section will display “Mute”.

The T 785’s front florescent display will show activity of the zone control 

so that main room occupants are aware of the zone remote activity. 

Furthermore if there is no main room activity, only the zone indicator will 

be active in the T 785’s fluorescent display.

NOTE

The ZR 4 remote control will only control Zone 2 applications. Zone 

3 and Zone 4 could be configured and managed at the appropriate 

Zone OSD menu using the front panel navigations keys as well as 

the corresponding keys on the HTRC 1 remote control. The HTRC 1’s 

“CUSTOM” device is also defaulted to Zone 2 remote control codes.

48

ENGLISH