NAD T785 Owner's Manual - page 19

SOURCE SETUP 

From Setup Menu, pressing   will direct you to the Source Setup menu 

wherein you could adjust allocate or change the settings of the following 

– Source Setup (Normal View), Source Setup (Table View) and iPod Setup.

SOURCE SETUP (NORMAL VIEW)

The Source Setup (Normal View) menu makes it possible to set, allocate or 

change the following settings.

SOURCE

The T 785 is equipped with ten configurable Sources. The settings for each 

Source are dependent on the configurations set forth in the parameters for 

that particular Source window. 

To change or toggle through the Sources, scroll to ‘Source’, press   button 

and then ENTER or 

 to move up or down the Source selections.

NOTE

Source 5 is defaulted to iPod. For Source 5 to be changed and allocated 

for other inputs, go to ‘iPod Setup’ menu under the ‘Source Setup’ menu.  

At iPod Setup menu, set ‘Enabled’ to ‘No’ – you can now assign Source 5 

to other inputs or settings as desired.

ENABLED

One can enable/disable a Source via this option. This is particularly useful 

if only few Sources are used and one directly selects the Source from the 

front panel, bypassing unused sources.

To enable or disable a particular Source, scroll to ‘Enabled’ and press 

keys to select ‘Yes’ or ‘No’.

NAME 

A new Name maybe assigned to a Source label. For example, if your DVD player 

is attached to ‘Source 1’, it is possible to rename ‘Source 1’ to ‘DVD Player.’ 

In order to rename the Source label, scroll to ‘Name’ and press   to go the 

character. Then, press 

 to pick through the alphanumeric selections. 

Press 

 to move to the next character and at the same time save the 

changes done on the current character. The name can be as long as twelve 

characters.

The new Name will be shown in the VFD as well as on the OSD.

ANALOG AUDIO

The T 785 has nine analog audio inputs including 7.1 input. These analog 

inputs - Audio 1, Audio 2, Audio 3, Audio 4, Audio 5, Audio 6, Audio Front, 

Audio MP and 7.1 Input can be variably assigned to each Source.

Scroll to ‘Analog Audio’ and then press   and then 

 to select and assign 

an analog audio input to the particular Source. There are three choices 

– Audio, 7.1 Input or Off. 

When ‘Audio’ is chosen, press   and then 

 keys to select and assign the 

desired audio input – 1 to 6, Front and MP.

Select ‘7.1 Input’ to choose the audio signal fed to ‘7.1 Channel Input.’ If ‘Off’ 

is selected, no incoming analog audio signal is selected by the particular 

Source.

NOTE

An incoming digital signal present at the assigned digital input will 

always take precedence over the assigned analog audio input, even if 

both are present. To maintain the analog audio input for the particular 

Source, select ‘Off’ at the ‘Digital Audio’ setting of the same ‘Source’ 

menu.

OPERATION

USING THE T 785 – SETUP MENU

19

ENGLISH