NAD T785 Owner's Manual - page 33

Tone Controls:  Tone Defeat: Off

Display Setup: Set “Line 2” to “Volume”

Picture Controls:  Aspect Mode – Stretch

5  With the above settings, scroll to “A/V Presets” from the SETUP MENU 

page. Use [   ] to access “A/V Presets” menu.

6  At “A/V Presets” page, set “Preset: 2” to the following conditions - use [ 

 ] 

to select “Yes” or “No” and press [ENTER] to confirm selection and move to the 

next setting

While at “Save Current Setup to Preset” menu line, use [   ] to save the 

settings above to “Preset 2”. When you recall “Preset 2” using the remote 

control (for HTRC 1, “A/V PSET” + “2”), the above preset values allocated 

at “Preset 2” (preset settings as shown in the OSD captures at Step 4) will 

be recalled and effected at the current source.

Note that “Speaker Setup” is set to “No”.  At this condition, there will be 

no “Speaker Setup” values that will be effected at “Preset 2”.  The “Speaker 

Setup” settings that will be applied at “Preset 2” will be the last or current 

“Speaker Setup” settings which in this sample are the same “Speaker 

Setup” settings shown above in Step 1.

7  You can setup up to 5 Presets.  These same Presets can also be 

associated/defaulted to each Source in the “Source Setup (Normal 

View)” window as below

In the above example, “Preset 1” settings are allocated for Source 1.  

Whenever Source 1 is accessed, the “Preset 1” settings will be applied to 

Source 1. You can still manually override the assigned Preset allocation in a 

specific Source with another Preset setting/number by way of pressing the 

appropriate remote control buttons.

RECALLING PRESETS

You may recall a Preset at any time using the HTRC 1 remote control.

Press the HTRC 1’s A/V PSET key and then the numeric key 1-5 

corresponding to the desired preset number. The newly recalled Preset will 

then manifest or replace the previous Preset (if any).

OPERATION

USING THE T 785 – SETUP MENU

33

ENGLISH