Nagel FOLDNAK 4 User Manual - page 5
5
4.1 Slat conveyor
The slat conveyor (fig001, 3) (option
with Foldnak 4) is folded upright for
transport and locked with a hook.
Raising the hook unlocks it and swings
it into an approximately horizontal
position. In this position the rod (11) is
guided into the hole of the foot stand as
a prop. The rear collecting plate (13) is
then hung downwards at an angle.
The axle and both wheels (10) are
accessories. They must be pre-mounted
with the set collars, which are also
accessories, so that both wheels are
exactly over the green conveyor belts
when the axle lays in the long vertical
slits of both axle brackets (12).
These axle brackets on both sides of the
slat conveyor are to be swung into a
vertical position and, after loosening
the knurled screws, then secured. When
not in use, the axle with the transport
wheels can be taken off, the axle
brackets folded towards the bottom and
the slat conveyor can be folded upright
and locked in order to save space.