Nagel FOLDNAK 4 User Manual - page 6
6
5 Preparation
5.1 Stapler heads / Stapler head
distance
Foldnak stapling-folding machines are
delivered with two stapler heads as
standard. They can be operated with up
to four stapler heads. The possible
stapler head positions are:
Type
Distances in mm
Foldnak 8
30 x 50 x 80 x 50 x 30
Foldnak 6
30 x 50 x 80 x 50 x 30
Foldnak 4
50 x 80 x 50
The stapler heads can be adjusted in the
previously given positions. For this, the
screws (21) behind the stapler head
batten (22) must be unscrewed with the
supplied hexagonal spanner, the stapler
head must be put into the desired
position with the spigots and screwed
tightly again.
The driver (20) is re-set as described in
Chap 8.2. By adjusting the stapler
heads and simultaneous adjustment of
the side stops, the position of the
staples in the paper can be altered. Care
must be taken that the stapler heads are
not placed over the side stops,
especially when the stapler heads are
used in the outer positions. Finally,
plug the contact cable (19) onto the
contact bank (18).