NAPCO F-TPBR Installation Instructions Manual - page 5
5
Remove the PC
Board by bend-
ing back 3 tabs
holding the PC
board in place.
Pull board up
slightly and
away from op-
posite side of F-
TPBR Touch-
pad housing to
remove.
Reinstall PC
board by first slid-
ing the board un-
der three fixed
tabs on the left
side of the hous-
ing. Then push
board under the
three movable tabs
until it snaps se-
curely into place.
6
Secure lens by
snapping the PIR
lens holder back
into place. Be sure
both tabs are se-
curely fastened to the
F-TPBR Touchpad
housing. Note: Be
sure grooved side of
lens is facing in
(smooth side is facing
out).
5
Be sure both tabs are secure
Up
JP1
ADDR
PIR
≠
AUX2
1
2
3
4
Thre
e fi
xe
d
ta
bs
Install the F-TPBR
Touchpad Face
Snap the front of the F-
TPBR Touchpad onto the
base by first inserting the 2
slots in the top onto the
corresponding tabs on the
base and then snapping
the bottom into place.
8
Re-connect speaker
by pushing plug back
into receptacle. Be
sure the speaker plug is
fully pushed into receptacle
allowing retainer latch to
secure the plug.
7
Plug
Receptacle
Wires
Be certain
retainer latch
secures plug
PC Board
In the center of the PC
board is a speaker,
with black and red wires
connected to a plug mated
to a receptacle. Remove
the speaker plug by push-
ing back the retainer latch
on the receptacle using a
small screwdriver and
carefully pulling plug out of
the receptacle.
2
Plug
Receptacle
Wires
Push retainer
latch back
PC Board
Small
Screwdriver
Snap out lens
holder with small
screwdriver and
pull out existing lens.
Replace with the Pet
Alley lens so that the
notch (as viewed from
back of case) is in the
bottom right position.
(The Pet Alley lens was
installed at the factory
when manufactured).
4
Push in tabs with small
screwdriver to remove holder
Up
Install Pet Alley Lens
as shown
New PIR lens position
(Grooved side
facing in)
3
JP1
ADDR
PIR
≠
AUX2
1
2
3
4
Push
tab up
Close up
view of
lower tab
P
C
Boar
d
Power-down the
system and re-
move the front of
t h e F - T P B R
Touchpad housing.
With the F-TPBR Touch-
pad disconnected, the
following steps can be
performed with greater
ease.
1
JP1
ADDR
PIR
≠
AUX2
1
2
3
4
Changing the Lens
In the event that the lens must be changed, use the following procedure:
Tab