NAPCO XP-400 Using Instruction - page 14
14
Glossary
Ambush Code - In the event that you are
forced by an intruder to disarm your sys-
tem, this special code can be used to dis-
arm the system, and simultaneously send
a silent alarm to the Central Station. If
your system has the Ambush feature en-
abled, the code assigned as the User 4
code will function as your Ambush Code.
Arming / Disarming - Turning the system
on or off by entering your user code at the
keypad.
Auto Interior Bypass - A feature which
allows the system to recognize when you
have not left the premises and automati-
cally bypass any interior zones, deactivat-
ing devices such as motion sensors, al-
lowing free movement throughout the
premises.
Battery - A backup source of power to
provide protection for a limited time in the
event of a power failure.
Bypass - the manual or automatic re-
moval of one or more protection zones
from the system. Press
C
and then
the zone number to bypass a zone.
Central Station - Monitors alarm, emer-
gency and trouble reports from the alarm
system and notifies proper authorities.
Chime - a keypad beep which indicates
that a door has been opened while the
system is disarmed.
Easy Exit - Allows an occupant to leave
the premises without disarming the sys-
tem. Pressing
A
and then
0
while
the system is armed will permit exit by re-
moving the protection on the Exit/Entry
door for 3 minutes.
Exit/Entry Delay - The amount of time
you are allowed to enter and leave the
premises when the system is armed.
Exit/Entry Zone - A zone which will allow
you to enter and leave the premises when
the system is armed.
Instant Protection - Arming without Entry
Delay while remaining on the premises.
(Press
A
4
while armed).
Keypad Sounder - A local warning de-
vice at the keypad to alert that Entry delay
has started.
System Trouble - A problem has been
detected in the system which may prevent
it from working properly. The
H
SYSTEM
light will be lit.
User Code - A four digit code which is
used to arm and disarm the system from
the keypad.
User 1 Code - A four digit code which can
be used to program, re-program and
erase user codes, as well as arm and dis-
arm the system from the keypad.
Zone - An area which is protected by a
security device. Your front door may be
designated as Zone 1, while the living
room motion detector may be Zone 2.
Refer to the Zone Label on your keypad
for the Zone Identification of your system.
XP-400_RPXP4GT_OI300.02_...
page 14
Friday, January 28, 2005 13:42
Composite