Napoleon GI 3600-N Installation And Operating Instructions Manual - Finishing
7
W415-0061 / C / 10.25.11
LOG
CENTER
LOG
RIGHT
LOG
LEFT
CHARCOAL
EMBERS
FRONT LOG
BACK LOG
FIGURE 6
To give your insert that authentic masonry fi replace look,
optional fi bre fi rebrick panels are available at your Napoleon /
Wolf Steel Ltd. dealer. Complete installation and maintenance
instructions are included with the kit.
PHAZER
TM
logs and charcoal embers, exclusive to Napoleon
Fireplaces, provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully
position the charcoal embers for a maximum glowing effect.
1.
Place the front log onto the main burner, pushing it as
close as possible to the burner ports without blocking/covering
them. The left and right spacing between the log ends and
the burner ports should be equal.
YOU MAY FIND IT EASIER TO PLACE SOME CHAR-
COAL EMBERS BENEATH THE FRONT LOG NOW.
2.
Place the back log onto the step located at the back
of the combustion chamber. The notch situated at the lower
right of the back log should be centered evenly above the pilot
assembly.
3.
While supporting the back log, to prevent it from fall-
ing forward, set the three smaller logs into the pockets and
grooves of the front and back logs, respectively.
Log colours may vary. During the initial use of the fi replace,
the colours will become more uniform as colour pigments burn
in during the heat activated curing process.
POSITIONING THE LOGS
IMPROPERLY WILL CAUSE FLAME
IMPINGEMENT AND CARBONING.
Randomly place the embers beneath the front log, covering
all of the burner area beneath the hollowed out section of
the log. Place the remaining embers along the front. Keep
ember dust away from burner ports to avoid plugging them.
Fine dust found in bottom of bag not to be used.
PHAZER
TM
logs and charcoal embers glow when exposed to
direct fl ame.
Use only certifi ed
PHAZER
TM
logs and charcoal
embers available from your Napoleon / Wolf Steel Ltd. dealer.
FINISHING
FIBRE FIREBRICK PANELS
LOG PLACEMENT
CHARCOAL EMBERS
FIGURE 7
UPPER LOUVRES
Insert the back edge of
the upper louvre into the
upper louvre clips.
SIDE VIEW
LOWER LOUVRES
Secure the lower louvre
assembly to the insert, us-
ing the 4 screws supplied.
FLUSH LOUVRE KIT, GI-1L
SIDE VIEW
UPPER
LOUVRE
LOUVRE
CLIP