National Cycle N925 Owner's Manual - page 3
Wire the Light Bar Assembly
1. Route the Light Bar Assembly wires over the Triple Clamp
and into the Headlight Shell.
2. Attach the wires according to the Right and Left Side
Instructions Below. (Scotchlok connectors & Slip Joint Pliers)
Watch the instruction for the differences in wire color
between the VN1500 and VN800.
Right Side of Light Bar
1. Red wire from the Light Bar connects to the Gray wire in
turn signal harness
2. Black wire from the Light Bar connects to Red wire with
blue tracer (VN1500) or solid blue (VN800) in turn signal har-
ness.
3. Blue wire from the Light Bar connects to:
Red wire with yellow tracer on headlight connector
(lo-beam operation.)
Red wire with black tracer on headlight connector
(Hi-beam operation.)
Left Side of Light Bar
1. Red wire from the Light Bar connects to Green wire in turn
signal harness
2. Black wire from the Light Bar connects to Red wire with
blue tracer (VN1500) or solid blue (VN800) in turn signal har-
ness.
3. Blue wire from the Light Bar connects to:
Red wire with yellow tracer on headlight connector
(lo-beam operation)
Red wire with black tracer on headlight connector
(Hi-beam operation)
Through Wire
Wire from light
bar, insert to stop
INSTRUCTION FOR VN1500D&E AND VN800B
Page 3 of 5 10-110725-000 06/03
WIRE THE LIGHT BAR VN1500D&E and VN800B