National Cycle N925 Owner's Manual - page 5
HORIZONTAL AIM
A. To adjust the Spotlights or Turnsignals right or left gently
rotate the lamp into the correct position. In the event that the
lamps become loose, refer to the procedure for vertical
adjustment.
2. VERTICAL AIM
(In addition to the tools needed for
installation)
Hex Key, 5/32" or 4mm
Deep Socket and Socket ; 9/16" or 14mm
A slotted 9/16” Socket (SNAP ON part #FRX 181, is one
source) will allow adjustment without having to
pull wires
A. Disconnect wire connections inside the Headlight Shell.
B. Pull the wires out of the Light Bar tube.
C. Turn the Turnsignal to provide access to the mounting screws.
D. Unscrew the Turnsignal mounting screws and remove the
Turnsignal (Hex Key).
E. Push the Spotlight wire up into the Spotlight Shell.
F. Loosen the nut on the Spotlight stud (Deep Socket).
G. Now, adjust the Spotlight. Reconnect the spotlight wire and illumi-
nate to verify its projection.
H. Push wire into the Spotlight Shell.
I. Firmly retighten the nut on the Spotlight stud.
J. Pull the wire out of the Spotlight Shell.
K. Reassemble in reverse order of disassembly.
L. Adjust the Spotlights and Turnsignals horizontally by rotating into
position.
M. Verify operation of the lights.
National Cycle, Inc. PO Box 158 Maywood, IL 60153-0158 USA
708-343-0400 Fax:708-343-0625 www.nationalcycle.com e-mail: info@nationalcycle.com
Page 5 of 5 10-110725-000 06/03
MAINTENANCE AND CARE
ADJUSTMENT PROCEDURE
The high quality chrome finish of your National Cycle light bar can bemaintained with any quality chrome cleaner and /or
polish.
Replacement Parts: Refer to page 1.