National Cycle N925 Owner's Manual - page 4
1. Remove the screws from the sides of the headlight shell
(Phillips screwdriver). Gently pry the headlight ring from
the shell- there is a notch for this on the left side of the shell
(flat screwdriver). Disconnect the plug on the back of the
headlight and set the headlight assembly and screws aside
for re-use.
2. Unplug the turn signal leads. They are the long, thin wire
terminals.
3. Feed the turn signal leads (the ones with the male pin
terminals) out of the back of the headlight shell.
4. Remove the turn signal bar from the lower triple clamp
(8mm wrench). Be careful while pulling the wires out of
the fork cover.
INSTALLATION - LIGHT BAR for
VN1600
1. Using the M6 x 16 Screws provided and the flat washers
removed in Setup Step 4 from the Turn Signal Bar, attach
the Light Bar to the lower fork crown. Tighten the screws
securely Figure 1.
2. Route the wires from the light bar in the same location as
the turn signal bar.
Wire the Light Bar Assembly for VN1600
1. Route the Light Bar Assembly wires into the Headlight
Shell.
2. Attach the wires according to the Right and Left Side
Instructions Below. (Scotchlok connectors & Slip Joint
Pliers)
Left Side of Light Bar for VN1600
1. Red wire from the Light Bar connects to Green wire in
turn signal harness
2. Black wire from the Light Bar connects to Red wire with
blue tracer in turn signal harness.
3. Blue wire from the Light Bar connects to:
Red wire with yellow tracer on headlight
connector (lo-beam operation)
Red wire with black tracer on headlight connector
(Hi-beam operation)
Right Side of Light Bar for VN1600
1. Red wire from the Light Bar connects to the Gray wire in turn
signal harness
2. Black wire from the Light Bar connects to Red wire with blue
tracer in turn signal harness.
3. Blue wire from the Light Bar connects to:
Red wire with yellow tracer on headlight connector
(lo-beam operation.)
Red wire with black tracer on headlight connector
(Hi-beam operation.)
Through Wire
Wire from light
bar, insert to stop
INSTRUCTION FOR VN1600
Page 4 of 5 10-110725-000 06/03
INSTALLATION - SETUP VN1600
Flat Washer
Route
wires to
this notch
Figure 1.
M6 x 16 Screw