National Instruments NI 5782R User manual and specifications - page 12
12
|
ni.com
|
NI 5782R User Manual and Specifications
c.
In the Configure Open FPGA VI Reference dialog box, click the Browse button
next to the Bitfile button.
d.
In the Select Bitfile dialog box that opens, select the bitfile for your desired target. The
bitfile name is based on the adapter module, example type, and FPGA module.
e.
Click the Select button.
f.
Click OK in the Configure Open FPGA VI Reference dialog box.
g.
Save the VI.
7.
On the front panel, in the RIO Resource pull-down menu, select an NI 5782R resource that
corresponds with the target that you configured in step 6.
8.
Select AI 0 in the AI Channel control.
9.
Set the Trigger Level (V) and the Record Size controls to the desired values.
10. In the Trigger Type box, select either Software or Data Edge. If you select Software, the
VI acquires data every time you click the Software Trigger button on the front panel of the
VI. If you select Data Edge, the VI acquires data every time an edge occurs.
11. Click the Run button to run the VI.
12. Click the Software Trigger button if you selected Software in the Trigger Type control.
The VI acquires data and displays the captured waveform on the Acquired Waveform
graph as shown in Figure 5.
13. Click the STOP button to stop the VI.
14. Close the VI.