National Instruments NI 5782R User manual and specifications - page 13
NI 5782R User Manual and Specifications
|
© National Instruments
|
13
Figure 5.
NI 5782 - Getting Started (Host) VI Front Panel
Creating a LabVIEW Project and Running a VI on
an FPGA Target
This section explains how to set up your target and create an FPGA VI and a host VI for data
communication. This section focuses on proper project configuration, proper CLIP
configuration, and how to access 5782 AI IO nodes. For more detailed information about
acquiring data on your NI 5782R, refer to the device-specific examples available in NI Example
Finder.
Creating a Project
1.
Launch LabVIEW. If LabVIEW is already running, select File»Create Project.
2.
In the Create Project dialog box, select LabVIEW FPGA Project and click Finish.
3.
In the Create New LabVIEW FPGA Project dialog box, select FlexRIO on My
Computer and click Next.
4.
If your FlexRIO device is connected to your system, select Discover Existing System. If
your device is not connected to your system, select Create New System and click Next.
5.
Select your device and click Next.