National Security Systems D360 User Manual - page 16
COMMAND
4
4
3. Identify yourself and your premises (account number, name, address,
etc.) and advise the operator of the services you wish to have
performed.
4. When the operator directs you, enter COMMAND 43 at your
Command Center keypad.
Press the
COMMAND
bar. The Command Mode indicator light
comes on.
5. Press the
4
key, and then press the
3
key. The telephone line
that the call was made from is not active when remote account
management is in progress. You may hang up the telephone.
6. When remote account management has been completed, your
telephone line is restored to normal service.
Enable Remote Account Management
I have this feature.
I do not have this feature.
Your security system has the ability to be managed remotely from the
Central Station without having a serviceperson on the protected premises.
By using COMMAND 4 3 you can enable remote account management
from the Central Station. Remote account management is done with the aid
of a specially equipped computer at the Central Station.
Typical remote account management changes may include: personal
passcode(s), entry/exit delay times, add or delete system arming
commands, etc. Before using COMMAND 43 follow the instructions
below.
To use COMMAND 4 3:
1. Ensure that your security system is disarmed.
2. Call the Central Station using this phone number:
_________________________________________
This number is designated for the Remote Account Manager. You must
make the call using the telephone located
______________________________________________________.