National Security Systems D360 User Manual - page 17
COMMAND
4
4
To use COMMAND 44:
1. Ensure that the security system is disarmed.
2. Press the
COMMAND
bar. The Command Mode indicator light
comes on.
3. Press the
4
key then the
4
again. Audible devices (both
interior and exterior) sound. To silence the audible warning, press any
numeric key of the Command Center keypad..
4. After silencing the audible devices, you may test detection devices.
Open a door or a window, or activate a motion sensor. The Command
Center display panel indicates the zone which you have faulted. This
verifies that individual devices are working properly.
5. To end the Local System Test simply press any numeric key on the
Command Center.
Local System Test
I have this feature.
I do not have this feature.
It is easy for you to test your security system without sending reports to the
Central Station. This
local system test
is performed only when the security
system is disarmed to ensure that your security system is operating
properly, and should be used to test your system regularly.
COMMAND 4 4 is used to test your security system. This command tests
your Command Center, the system's sounders (both interior and exterior)
and the system's detection devices. No alarm reports are sent to the Central
Station unless a 24-hour zone is faulted. (
Contact your Central Station
before you test your fire protection system because an alarm report may be
transmitted.
)
To test individual detection devices, simply activate sensors and open
protected doors and windows one-at-a-time. As detection devices are
faulted, the Command Center display panel indicates the faulted zone. This
verifies that the detection device is working properly.