NAVICOM RT-300 Installation And Operation Manual - Tri Watch
9
Press and release the DW/TRI button to terminate Dual Watch and
return to the previous working channel.
Press and hold the DW/TRI button to terminate Dual Watch mode
and go into Tri Watch mode.
Press and release the 16 button to terminate Dual Watch mode and
switch to the Priority channel.
Note: During Dual Watch mode, the SCAN and Channel / (UP/DOWN)
utton are inactive and sounds an error beep if pressed.
b
Tri Watch
Press and hold the DW/TRI key for 3 seconds to activate Tri Watch
mode. The TRI indicator appears on the LCD. Tri Watch monitors in
cycle Channel 16, the current working channel and the channel you
have set as the Favourite (PLUS) Channel. Tri Watch is
demonstrated in the figure to the left; the sample working channel is
CH 72.
Press and release the DW/TRI button to terminate Tri Watch and
return to the previous working channel.
Press and release the 16button to terminate Tri Watch mode and
switch to the Priority Channel.
Note: During Tri Watch Mode, the SCAN, and Channel / (UP/DOWN)
eys are inactive and sounds an error beep if pressed.
k
Resetting your Radio
You can reset many radio settings back to their factory defaults, this
will:
• Erase any channels stored in memory
• Return to International channels, if another mode is selected
• Only For US version
• Return power settings to their original state
To perform the reset:
1. Turn the radio OFF.
2. Simultaneously press and hold the SCAN & DW buttons.
3. While continuing to hold these keys, power the radio ON.
The LCD remains blank for 2 seconds, and then the unit switches to
channel 16.