NAVICOM RT-300 Installation And Operation Manual - Adding Channels To Memory
8
Adding Channels to Memory
Your RT300 can store any channel (including Private Channels).
The stored channels are the ones scanned in the Saved (Memory)
Scan mode.
To Add Channels to Memory
1. During normal operation mode, use the UP or DOWN key to select
the desired channel for programming.
2. Press and hold the SCAN / MEM key for 3 seconds.
The "M" icon appears to indicate the current channel has been
saved in memory. Any number of channels can be saved as memory
channels.
To Delete Channels from Memory
1. During the normal mode, use the UP or DOWN key to select the
channel to be deleted.
2. Press and hold the SCAN / MEM key for 3 seconds.
The selected channel is deleted from memory.
Using the Monitor Modes
The Watch Modes monitor the programmed Priority Channel and
other user selected channel(s). The watch is halted when activity is
detected on a monitored channel. Your RT300 is equipped with
2 types of monitor operations: Dual Watch and Tri Watch.
Note: Monitor modes are disabled when the ATIS operation is active.
Dual Watch
Press and release the DW/TRI button to activate the Dual Watch
mode. The "Du" indicator appears on the LCD. Dual Watch monitors
the current working channel and Channel 16 in cycle. Dual Watch is
demonstrated in the figure to the left; the sample working channel is
CH 72.