Navin miniHomer User Manual - page 10
NAVIN Corporation
www.navin.com.tw
Checking Free Marking Coordinates
1. Click Power/Mode key to select Free Marking icon
.
2. The manually entered latitude (ddmm.mmmm) and
longitude (dddmm.mmmm) coordinate can be checked
by clicking Mark key. You will see latitude degrees shown
first, then latitude minutes and first decimal digits
shown, then the lower three decimal digits shown lastly;
with
denoting northern hemisphere and
denoting southern hemisphere.
3. Next longitude degrees is shown first, then longitude
minutes and first decimal digits shown, then the lower
three decimal digits shown lastly; with
denoting
western hemisphere and
denoting eastern
hemisphere.
Note that the unit of latitude and longitude coordinates
used in miniHomer is degrees and decimal minutes.The
latitude has 8 digits and the longitude has 9 digits, for
example, the latitude may be N24°47.0967’ and the
longitude may be E121°40.5236’.
Go to a Free Marked Location
1. Click Power/Mode key to select Free Marking icon
.
2. Make sure satellite icon
is not blinking and showing
arcs.
3. The displayed number shows distance to the stored
location, and the direction arrow shows the direction to
follow.
4. After reaching the destination, within a 5 meter (or 20
feet) radius, the circle of direction arrows will show up.