Navman Halo Qube 2 Installation Manual - page 11
Qube 2
Combination GPS/GPRS
Antenna
ConEx Unit
Connect Vehicle Power
Connections here
11
Halo QUBE 2
|
Installation Manual V1.0
Connecting an External ConEX
Note: Please check with your distributor, to see if this feature is available yet.
An external ConEX would be connected if: The user requires additional IO lines, additional serial capture
port, or has custom ConEX code that needs to be used with their system.
The Qube 2 will connect into the connector marked “HALO - QUBE”. The wire colours do not directly
match. Please connect the Qube 2 using the table below.
Please refer to the ConEX installation manual for all other ConEX connections.
RJ45 Connector - Cable A Male plug, Cable B Female socket
ConEX
Connections
Cable A
Cable B
Qube 2
Function
Description
RD
Red
Red
+12/24 V
Power
OR
Pink
Pink
Ignition
Ignition
GR
-
-
-
Do not connect
WH
-
-
-
Do not connect
YE
-
-
-
Do not connect
BL
DB9 - Pin 3
Purple
TxD
Serial data output
BR
DB9 - Pin 2
Brown
RxD
Serial data input
BK
Black
Black
GND
Ground
Note: The MDT port on the ConEX box will no longer function. Please use the RJ45 connector on the Qube 2 cable to
attach an MDT / PDT etc.