Navman Halo Qube 2 Installation Manual - page 12
12
Halo QUBE 2
|
Installation Guide V1.0
Testing
Check Correct Ignition connection
Use a multi-meter to measure the voltage at the ignition line connected to the Qube 2.
1. Turn the key to the accessories position. Check that there is no voltage on the ignition line.
2. Turn the key to the IGNITION position. Ensure that +12 / 24 V DC is present at ignition line.
3. Watching the meter, start the vehicle and ensure that the voltage does remain ON during starting.
If any of these tests fail, the Qube 2 is not connected to the correct signal. Please find the correct wire
Check Data and GPS
1. Ensure the vehicle is outside, so the GPS antenna has a clear view of the sky, and there is good
cellular coverage.
2. Turn the Ignition Key on to the ignition position.
3. Check that all 3 LED’s come ON. This may take up to 15 minutes, but is normally less than 2
minutes.
Fault Finding
Power LED fails to light
Check that the +12 / 24 V wire has permanent power connected
to it.
Check the DB15 I/O connector is correctly connected, and the
securing screws are hand tightened onto the Qube 2.
GPS LED fails to light
Ensure that the antenna is up the correct way, and has a clear
view of as much of the sky as possible.
Check the antenna connectors are correctly connected, and
hand tightened onto the Qube 2 connectors.
It may take up to 15 minutes for a first GPS fix after the unit has
been shipped un-powered to a new location.
GPRS LED fails to light
Check the antenna connectors are correctly connected, and
hand tightened onto the Qube 2 connectors.
Check if the area has GPRS coverage.