Navman Halo Qube 2 Installation Manual - page 8
8
Halo QUBE 2
|
Installation Guide V1.0
Wiring
Cable A
Has a long cable with a RJ45 Plug, a short cable with a DB9 plug, and a single cable with bare ends for
all other connections.
Cable B
Has an RJ45 socket very close to the main plug (DB15), and a single long cable with bare ends for all
other connections.
Power Connection - Bare wires
Cable A
Cable B
Function
Description
Red
Red
+12/24 V
Main Power Connection - Connect to
a fused supply
Pink
Pink
Ignition
Positive input from vehicle when the
key is in the IGNITION position (not
the accessory position). This signal
must remain on DURING starting
of the vehicle - Connect to a fused
supply.
Black
Black
GND
Vechicle ground / chassis connection
Important Notice
If fitting a MDT-800 (Mobile Data Terminal) the main power connection (red wire) must be
connected to +12 V DC only. The Qube 2 ignition and Multi IO lines may still be connected to
24 V DC.
MDT or PDT Connection
RJ45 Connector - Cable A (Male plug), Cable B (Female socket)
Cable A
Cable B
Function
Description
Pin - 1
Pin - 1
GND
Ground
Pin - 2
Pin - 2
+12/24 V
Power
Pin - 4
Pin - 4
Serial RxD
Serial data Input
Pin - 5
Pin - 5
Serial TxD
Serial data Output