Navnet TZ 2 touch Installation Checklist - page 4
4
If the transducer is listed as being eligible for “Enhanced” RezBoost mode,
please enable Enhanced mode in the Fish Finder Pop-Up menu.
Select the preferred data/sensor sources for the network by pressing the
“Data Source” button in the “Initial Setup” menu.
Select the NMEA2000 PGNs that you want to output on the NMEA2000
backbone from the “PGN Output” button of the “Initial Setup” menu.
Note: The PGN output configuration is a global setting in the network. The
PGN output settings are shared among all TZtouch2 MFDs. However, only
one MFD will actually output data on the NMEA2000 bus (the MFD that was
powered ON first). If that MFD is turned OFF or fails, another TZtouch MFD
will automatically replace it and begin outputting the same PGNs onto the
NMEA2000 backbone.
Pick one TZtouch2 MFD as the Chart Master and select “ON” in the “Chart
Master Device” setting from the “Initial Setup” menu.
Select the preferred Units from the “Units” menu.
Proceed to the Local Time Offset and adjust the desired time offset in the
General menu.
Configure the NMEA0183 Output Port for each MFD that has an NMEA0183
interface. Each TZtouch2 MFD has an independent NMEA0183 Output Port.
If a SiriusXM BBWX3 Satellite Weather Receiver is installed in the network,
set the “Weather Data Server” to “Sirius” from the “Weather” menu, as per
customer preference. This setting can be changed at any time and both
weather services may be used at will.
Any TZtouch MFDs (1
st
generation) in the network should be configured
according to the original
TZtouch Installation Checklist
. Note that
NMEA2000 PGNs will be a global output for both TZtouch2 and TZtouch
MFDs.